Imperite I.F. 503
Product Description
Resene Imperite I.F. 503 is a high performance finish for use when an isocyanate-free topcoat is required. Two-component finish for a wide variety of suitably prepared substrates in all but the most demanding environments. Quick dry properties allow early handling of coated items. Available in solid and metallic pigmented colours.
Typical uses:
- Aluminium
- Concrete/plaster
- Fibre cement
- G.R.C. panels
- GRP
- Repaints
- Structural steel.
Colour: White, selected BS2660, BS5252 and Resene Total Colour System, The Range and Metallic Effects.
Performance:
1. Isocyanate free.
2. When used as the finish over Resene Armourcote 220 (see Data Sheet RA34), same day turnaround of the total system can be achieved.
3. Exterior weathering properties are similar to a high quality pure acrylic topcoat.
4. Overcoat with Resene Uracryl 400 Series UVS clears for improved colour fastness (all metallic finishes), durability, and chemical resistance. Allow Resene Imperite I.F. 503 base colour to cure for a minimum of 48 hours with good ventilation before applying the Resene Uracryl 400 Series UVS clear.
Limitations:
1. In environments where maximum chemical and solvent resistance is required the use of two-component epoxies or polyurethanes is recommended.
2. Not recommended for prolonged immersion in fresh or saltwater or solvents.
3. Full cure may take up to seven days depending upon environmental conditions. In early stages or curing, film may be susceptible to mechanical damage.
4. Suitable for brush or roller application on small areas only.
5. Not recommended for direct application to Resene Vinyl Etch (see Data Sheet RA31), Resene Armourcote 210 (see Data Sheet RA35) or inorganic zinc rich primers.
Please ensure the current Data Sheet and Safety Data Sheet are consulted prior to specification or application of product. If in doubt contact Resene. Enjoy the Resene Promise of Quality Guarantee on Resene decorative coatings - see Resene for more information.
Resene decorative coatings are tinted using unique Resene non VOC tinters enabling you to achieve the desired colour without added VOCs.
Engineered Systems Coatings products are tinted using special Resene industrial tinters. Remember Resene can create a customised specification free for your project - contact us for more information. Order colour charts and drawdowns of Resene colours from the Resene website.
