Armourcote 512

Resene Armourcote 512 is a high build, gloss epoxy finish that protects concrete and metals against corrosion and chemical degradation. Fully cured film is hard and abrasion resistant.

Typical uses:
- Concrete surfaces
- Galvanised steel
- General marine use
- Piping, pulp and paper plants
- Repaints
- Structural steel
- Tank exteriors
- Waste/water treatment plants.

Colour: Near white, selected BS2660, BS5252 and Resene Total Colour System.

Performance:
1. High build, abrasion resistant finish.
2. Resistant to solvents and a wide range of chemicals including dilute mineral acids.
3. Near white epoxy finish.
4. Suitable for use as a tanklining and immersion in fresh and saltwater.
5. Ultimate film properties will require two weeks cure time.

Limitations:
1. This product will chalk when continuously exposed to sunlight. This chalking in no way impairs performance.
2. Not recommended for constant immersion in acids, alkalis or solvents (consult manufacturer for specific recommendations).
3. Do not apply over thermoplastic coatings.
4. Extended cured times are required before immersion service.
5. Cure rates are retarded at temperatures less that 10ºC.

Please ensure the current Data Sheet and Safety Data Sheet are consulted prior to specification or application of product. If in doubt contact Resene. Enjoy the Resene Promise of Quality Guarantee on Resene decorative coatings - see Resene for more information.

Resene decorative coatings are tinted using unique Resene non VOC tinters enabling you to achieve the desired colour without added VOCs.

Engineered Systems Coatings products are tinted using special Resene industrial tinters. Remember Resene can create a customised specification free for your project - contact us for more information. Order colour charts and drawdowns of Resene colours from the Resene website.