Zincilate 11

Resene Zincilate 11 is a sacrificial priming system for steel with superb anti-corrosive properties. May be applied in conditions up to 95% humidity. Eliminates rust undercutting. Excellent resistance to abrasion and impact damage.

The performance is equivalent to the more common two pack systems with the following significant benefits:
1. Eliminates mixing procedures on-site and the errors this can cause.
2. Eliminates waste as unused material can be stored for subsequent use.
3. A mechanically agitated pot is no longer necessary.
4. A bottom outlet pot becomes optional.

Colour: Grey/green.

Typical uses:
- As a primer/finish coat
- As a tanklining for petroleum solvents, structural steel, pipelines or storage tanks for petro-chemical refining, pulp and paper plants, drilling rigs and power stations
- As a weld through primer applied at 12 microns - no burn back.

Performance:
1. Gives long-term corrosion protection to steel equivalent to two pack inorganic zincs.
2. Unsurpassed solvent resistance.
3. Excellent resistance to abrasion and impact damage.
4. Provides excellent protection to steel without the necessity for overcoating.
5. May be applied under cold, damp conditions.
- As a permanent primer for organic topcoats such as epoxies, vinyls, chlorinated rubbers or urethanes.

Limitations:
1. Before topcoating check that the film is cured by testing resistance to rubbing with a rag wrung out in Resene Thinner No.12.
2. Ensure surface is clean, dry and free from soluble salts before overcoating.
3. Coating will not cure at R.H. lower than 40% - undercured coatings may be cured by keeping damp with water spray after the film has set.
4. Sensitive to acid or alkali solutions.
5. Non-saponifiable barrier coat must be used when overcoating with solventborne systems.

Please ensure the current Data Sheet and Safety Data Sheet are consulted prior to specification or application of product. If in doubt contact Resene. Enjoy the Resene Promise of Quality Guarantee on Resene decorative coatings - see Resene for more information.

Resene decorative coatings are tinted using unique Resene non VOC tinters enabling you to achieve the desired colour without added VOCs.

Engineered Systems Coatings products are tinted using special Resene industrial tinters. Remember Resene can create a customised specification free for your project - contact us for more information. Order colour charts and drawdowns of Resene colours from the Resene website.